Terms & disclaimer
WattageFit provides informational planning and calculation tools. It is not an electrical or carbon-monoxide safety certification, permit approval, site survey, engineering service, repair service, utility bill or substitute for manufacturer or public-authority instructions.
Charging estimates
Real charging behavior can vary with battery level, temperature, firmware, charger power-sharing rules, cable quality, device configuration, connector condition and negotiated USB-PD profiles. Results are estimates based on published ratings and user inputs, not live electrical measurements.
Electricity-cost estimates
Regional electricity calculators estimate consumption and cost from user inputs, editable assumptions and published tariff parameters. Actual consumption can differ because of duty cycle, inverter behavior, temperature, appliance condition and usage. Actual charges can also differ because of account classification, subsidies, fees, billing rules or tariff changes. For Kuwait, the customer’s current MEWRE classification and official bill take priority over WattageFit’s estimate.
Standby-generator placement prechecks
The generator planner uses simplified geometry, manufacturer-sourced starting values and user-entered local requirements to screen candidate locations. It does not establish code compliance, determine a legal setback, verify a property line, account for every opening/overhang/easement, size gas or electrical systems, or certify that a location is safe. The exact model manual, applicable permits/codes and qualified installers or inspectors required in the user’s jurisdiction take priority.
A “no conflict found” result means only that the values entered into the simplified checks do not conflict. It is not permission or instruction to install.
Source changes and unknown thresholds
Manufacturer specifications, firmware behavior, product revisions and public tariffs can change after publication. WattageFit distinguishes published minimums from supply/fast-charge references and leaves a lower minimum or workload threshold unknown when the cited source does not publish one. Users should verify critical decisions against current manufacturer documentation or the relevant public authority.
Use safe equipment
Use undamaged, standards-compliant chargers, cables and mains-powered equipment from reputable manufacturers. Stop using equipment that is damaged, unusually hot, swollen, wet or otherwise unsafe. Do not use this site as instructions to open, modify, bypass or repair power supplies, batteries, cables, wiring or appliances.
Limitation of responsibility
To the maximum extent permitted by applicable law, WattageFit is provided on an “as is” and “as available” basis without a guarantee that every result is complete, current or suitable for a particular device or use. The site operator is not responsible for loss or damage arising from reliance on an estimate where a manufacturer specification, product condition, negotiated charging behavior, appliance load, tariff classification or official bill differs from the model shown here. Nothing in these terms excludes rights or liabilities that cannot legally be excluded.
External links
Links to manufacturers, standards bodies, public authorities and other third parties are provided as sources or convenience. WattageFit does not control those websites and is not responsible for their content, availability, privacy practices or transactions. A source link does not imply endorsement or official approval.
Advertising and affiliate disclosure
WattageFit uses Google AdSense to display advertising. Ads are separate from calculator results and editorial content, and consent-dependent advertising technologies are governed by the privacy choices presented where required. WattageFit does not currently use affiliate tracking links. See the Advertising disclosure for the current advertising policy.
Local rights and mandatory law
These terms do not override mandatory consumer, privacy, product-safety or other rights that apply in a user’s jurisdiction. Where a limitation in these terms is not permitted by applicable law, that limitation applies only to the extent legally permitted.
Trademarks and public authorities
Third-party product names, company names and trademarks belong to their respective owners. References to MEWRE or any other public authority are descriptive and do not mean WattageFit is affiliated with, endorsed by or acting on behalf of that authority.
Effective September 22, 2026.